Built with N-Channel mosFETs and an ultra fast Atmel MCU & heartbeat make this a high performance ESC with excellent sync capabilities. Programmable via an R/C controller.It allows you to program all functions to fit your specific needs, which makes it efficient and user friendly.
Features:
Extremely low internal resistance
Super smooth and accurate throttle linearity
Over heat and over-load protection
Auto shut down when signal is lost or radio interference becomes severe for more than 2 seconds
Supports high RPM motors
Power arming protection (prevents the motor from accidentally running when switched ON)
New Advanced programming software
Programming features:
Brake setting (we recommend using brake for only folding props applications)
Battery type(LiPo or NiCd/NiMh)
Low voltage cutoff setting
Factory default setup restore
Timing settings (to enhance ESC efficiency and smoothness)
Soft acceleration start ups (for delicate gearbox and helicopter applications)
Governor mode(for helicopter applications)
Motor rotation( clockwisecounterclockwise)
Switching frequency
Low voltage cutoff type (power reduction orirnmediate shutdown)
Factory default settings:
Brake: off
Battery type Detect: LiPo with Automatic Cell
Low voltage cutoff threshold: Medium (3.0V/65%)
Timing setup: Automatic
Soft Acceleration Start Up: Medium
Governor mode : OFF
Frequency : 8kHz
Low voltage cutoff type: Reduce power
Spec.
Cont. Current: 12A
Burst Current: 16A/10sec
Battery: 2-4 Cell Lipo / 5-12 Cell Ni-XX
SBEC: 5V/ 1A Output
Size: 22*21*4mm
Weight: 10g
Normal ESC start up procedure:
-
Switch your Transmitter ON and set the throttle to its minimum position.
-
Connect the battery pack to the ESC.
-
When the ESC is first powered up, it emits two sets of audible tones in succession indicating the status of its programming state.
* The first set of tones denotes the number of cells in the LiPo pack connected to the ESC. (Three beeps (***)indicates a 3 cell LiPo pack while 4 beeps (****) indicates a 4 cell LiPo pack).
* The second set denoting Brake status (one beep(*) for Brake “ON” and two beeps (**) for Brake “OFF”).
*The ESC is now ready for use.
