The new XT60+ with “snap on” insulating end caps to provide the best polarity insulation for your soldered connections. Thanks to the snap on end cap there is no need to use heatshrink and the ridged edges on the end cap provide extra grip when pulling the male and female connectors apart.
Initial assembly requires a little force to clamp the end cap in place but please note that the end cap is hard to disassemble once it has been installed. Should you wish to remove the end cap you will have to “break it” with both hands to get it to release.
Material: Gold-plated copper
External Material: Nylon/PA
Max. : 60A
Pulling Force/600: 3kg
Temperature Resistance: -20°C~120°C
Recommended Cable Spec.: 12AWG
Recommended Soldering Spec.: 480°C/4S
5 x male plugs
IMPORTANT: “These are not cheap copied XT60 plugs. These original Nylon XT60 plugs, can handle over 60A current for extended periods without exceeding 80DegC thanks to their better contact surface area. The plug is also less likely to deform or melt in comparison to copied non-Nylon XT60 plugs.”