Product Description
The Digilent Cmod A7 is a small, breadboard friendly 48-pin DIP form factor board built around a Xilinx Artix-7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM, Quad-SPI Flash, and basic I/O devices. These components make it a formidable, albeit compact, platform for digital logic circuits and MicroBlaze embedded soft-core processor designs using Xilinx’s development software, Vivado. There are 44 Digital FPGA I/O signals and two FPGA Analog inputs that are routed to 100-mil-spaced through-hole pins so that you can integrate your programmable logic design directly into a solderless breadboard circuit. At just 0.7” by 2.75”, it can also be loaded in a standard socket and used in embedded systems.
Support Materials
Datasheet (PDF)Schematics (PDF)
For all other material:
Note:
The only difference between the Cmod A7-15T and Cmod A7-35T are the capabilities of the FPGA found on the board. They compare as follows :
Features:
System Features
-
512KB SRAM with an 8-bit bus and 8ns access times
-
4MB Quad-SPI Flash
-
USB-JTAG Programming Circuitry
-
Powered from USB or external 3.3-5.5V supply connected to DIP pins
System Connectivity
-
USB-UART bridge
Interaction and Sensory Devices
-
2 LEDs
-
1 RGB LED
-
2 Push Buttons
Expansion Connectors
-
48-pin DIP connector with 44 Digital I/O and 2 Analog inputs (0-3.3V)
-
One Pmod connector with 8 Digital I/O